Automatic tin feeder
Automatic tin adding machine V-833
First, the introduction of old technology and adverse effects:
The traditional tin soldering process, first open the door, and then 1KG/ the tin tin to put on this.
Simple operation, there are a lot of insecurity and environmental protection, the reasons are as follows:
1, open the door, tin easily distributed temperature, power consumption less energy, add more oxygen into the furnace, increasing oxidation,
Tin consumption is not energy saving;
2, put the tin, tin is easy to spill out, high temperature hot, not safe;
3, according to the experience should be put into a few tin bar, no specific data and guidance, can not detect. Many places will be less
Affect the stability of the wave, seriously affect the welding process.
4, if there are new and old customers to visit the workshop, at this time is about to add tin, the staff did not care to handle burns, not only affect the company
Reputation, but also to reduce customer satisfaction with the company.
Two, in the installation of the Vzilink wave soldering automatic tin wire machine after the following:
1, the equipment can be installed in the major brands of wave soldering machine shell (simple installation, will not use any electrical equipment
And the structural parts, only a few fixed holes can be drilled on the casing, and the tin wire is automatically introduced into the wave soldering tin furnace
In the future, no longer need to open the door to join the appropriate amount of tin, that is safe and environmentally friendly.
2, in the furnace is installed on the liquid level sensor, liquid level automatically recharge, the liquid level can be set by the process engineer,
The detection and control of liquid level is improved.
3, the speed of tin can be adjusted, can be prepared by the process engineer SOP guide specification operators must strictly in accordance with their requirements
Set to control the tin content.
4, the equipment is configured to automatically detect tin plate device, tin plate without material automatic alarm prompt operator should replace the tin plate.
5, the equipment to 3mm wire diameter tin wire, the average amount of tin per hour can be as low as 0.35Kg/H, according to 12 hours
Production time is calculated before the cumulative 4.2Kg. compared to the traditional daily 10Kg tin bar to save 5.8Kg tin material on the daily
Save hundreds of dollars of material cost for the company.
6, the installation of this equipment, not only to improve the level of your company's hardware facilities, but also reduces the cost of the company
And the risk of production management, but also reduce the workload of the production line staff.
Equipment specification parameter:
Model V-833
Outline dimension (L*W*H) 405mmX350mmX585mm
Color computer white
Weight 25KG
Operating voltage AC220V
Rated power 100W
Tin feeding speed 0.1-3.5M/min
Tin wire diameter 3-8mm
Tin plate dimensions (outer diameter * inner diameter * thickness) 250X o 35X140mm
Material tray detection
A tin liquid level detection
Tin: reel tin.
Tin bearing: 30kg
Two: picture display 1
